Hello DIYs,
I have the same trouble as Bart - In DVT software I can't create EDS file and can't switch to Pre-operational mode. SW always says "Access level is too low".
Did somebody find what is wrong? Is there some colission with other software in the PC?
I have Windows 10 (2004), newest version of DVT (2021.06), Ixxat USB-to-CAN v2 converter, SEVCON GEN4 size4 controller and Motoenergy motor. DVT and TCL are installed directly on C drive root - as my dealer adviced me.
As user Dala replied above - is possible to switch controller to Pre-op mode directly with CAN message "0x000 0x80 0x00" but controller fall to error "4f01 Bad State" and setting isn't possible again :-(
Many thanks for all advices!
Carli
I have the same trouble as Bart - In DVT software I can't create EDS file and can't switch to Pre-operational mode. SW always says "Access level is too low".
Did somebody find what is wrong? Is there some colission with other software in the PC?
I have Windows 10 (2004), newest version of DVT (2021.06), Ixxat USB-to-CAN v2 converter, SEVCON GEN4 size4 controller and Motoenergy motor. DVT and TCL are installed directly on C drive root - as my dealer adviced me.
As user Dala replied above - is possible to switch controller to Pre-op mode directly with CAN message "0x000 0x80 0x00" but controller fall to error "4f01 Bad State" and setting isn't possible again :-(
Many thanks for all advices!
Carli
