Is it still available?
SOLD Remy HVH250-090S Motor
Why fool around with homemade housings? Mega-torque! Base speed and power depends on voltage. Used in a street motorcycle conversion and ridden approximately 500 miles. Gen 1 housing, includes parts as shown in pictures: waterjet cut motor mounts, power cables, sensor cable and oil pan conversion as recommended by Remy engineers. (This allows use a smaller and quieter circulating pump. The conversion is reversible: simply unbolt the oil pan and replace with a block-off plate.)
This motor is well understood by controller manufacturers and I used it with a Rinehart PM100DX. $2500 OBO + shipping. Please contact me if any questions or for additional pictures or information.
Application Manual: http://www.neweagle.net/support/wiki...al20110408.pdf
Side View by Frank
Input from Controller by Frank
Motor shaft by Frank
Bottom of Remy motor showing oil pan by Frank
Remy motor serial number by Frank
Misc. Parts included by Frank, on Flickr
This motor is well understood by controller manufacturers and I used it with a Rinehart PM100DX. $2500 OBO + shipping. Please contact me if any questions or for additional pictures or information.
Application Manual: http://www.neweagle.net/support/wiki...al20110408.pdf
Side View by FrankInput from Controller by FrankMotor shaft by FrankBottom of Remy motor showing oil pan by FrankRemy motor serial number by FrankMisc. Parts included by Frank, on Flickr
6
