DIY Electric Car Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
23 Posts
Discussion Starter #1
hi!

i just received my order of spectro mega lugs and found a unexpected surprise... they leak! since i am crimping instead of soldering, in your opinion should I:

a: get a hammer + anvil and beat them into submission
b: sweat some 60/40 into the voids from the outside of the lug
c: seal them from the inside by dropping a little solder into the fillet and heating
d: buy another tub of no-ox-id and attempt to fill the fillet from inside the lug prior to assembly

personally, im leaning towards "b"... any experienced opinions will be much appreciated! cheers!
-sj
 

Attachments

·
Registered
Joined
·
7,838 Posts
i just received my order of spectro mega lugs and found a unexpected surprise... they leak! since i am crimping instead of soldering, in your opinion should I:
....any experienced opinions will be much appreciated! cheers!
Hi sj,

They look just fine to me. Use them "as is". And what do you think they will leak, electrons :rolleyes:

major
 
1 - 3 of 3 Posts
Top