DIY Electric Car Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
21 Posts
I am in the process of wiring up my two chargers now and I am in need of some guidance on the proper way to wire them. What I am unsure of is how to connect the AC power in to the modules.

I am in the US so power will be single phase which means the modules will all parallel, but does this mean I simply split the AC power from the 1772 port into 3 separate hot and grounds and feed power into each module, or do I only connect power to module 1? Seems to me that the only way to get sufficient current carrying capacity is to put power to all 3 module inputs but I am unsure.

Any help would be appreciated!
 

·
Registered
Joined
·
21 Posts
I've got a question about the inputs and outputs of the charger. I know A3 is the enable input, but I'm wondering if A10 is a user configurable input? and the same question for A1, A2, and A6. Are those user configurable outputs?

And if so, are they 12v in/out?

Thanks,

Blakely
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top