I was just at this moment looking at the github for this and logged on here to find the original discussion to learn more about it. I have not looked into a BMS system yet for my tesla batteries so probably have some newb questions.
My current understanding is i wire the BMS boards together and plug them into a arduino due or teensy 3.2. What i'm not sure is what happens from there.
How does the arduino tell the charger/ controller to start or stop.
how do these relate to a precharge resistor?
Thanks for your advice.
My current understanding is i wire the BMS boards together and plug them into a arduino due or teensy 3.2. What i'm not sure is what happens from there.
How does the arduino tell the charger/ controller to start or stop.
how do these relate to a precharge resistor?
Thanks for your advice.
