DIY Electric Car Forums banner
1 - 1 of 1 Posts

3 Posts
Discussion Starter · #1 ·
I got my hands on an Tesla gen 1 charger that I would like to use in my EV but I need the CAN message standard to enable the charger and set the voltage and amp level.
Would I be so lucky that one on this forum have a starting point that I could try to send to the charger and would like to share it?


1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.