DIY Electric Car Forums banner
1 - 1 of 1 Posts

40 Posts
Discussion Starter · #1 ·

I'm currently in the process of trying to get my Tesla large drive unit set up in a bench configuration so that I can test my ability to control it using Damien's controller board. To get that going I have a power supply for the 12V supply, however am looking to shop for an additional power supply that can motivate the motor back and forth (at slow speeds). Wanted to get input on anything I should consider as I'm browsing Amazon for various power supplies. Is there a minimum amount of power I'll need?

Note that I haven't decided on my final battery pack yet hence this setup versus attempting to connect real batteries to it.

1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.