DIY Electric Car Forums banner


861 Views 5 Replies 4 Participants Last post by  cricketo
Hi all
Im underway with concept planning for a low spec Classic car conversion with the DC forklift motor option and getting what I need for that.
First question is, I have a 72V DC 400a "Curtis" controller and looking at a pedal throttle running 0-5V not 0-5ohm as seems to be referred to in my research
Will they talk to each other?
1 - 2 of 2 Posts

· Registered
Triumph Herald '65
3 Posts
Discussion Starter · #5 ·
Bit hard reading model number as its a used one but looks like 1205M which looking up manual(Thanks for advise there) calls it Type 2 throttle(to J3 input) but I think suggests programming controller for that?
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.