DIY Electric Car Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Hi there,
My charger has canbus protocol. I also bought usbcan analyzer. For example the battery will charge up to 5V by giving 5A. Afterwards, it will give a constant 5V and stop charging at 2A. How can I make this application?
How should the connection diagram be?
Can I do this application in usbcan analyzer interface? (USBCAN has a interface)
Do I need to use Arduino?
Will the connection be made between the charger-bms-battery?
I am uploading the user manuals of the charger and usb can device.
Thank you
Çağlar Gediksiz
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top