DIY Electric Car Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 · (Edited)
I just joined this nice forum, looks interesting. I have a battery system with 3 x 24 Valence XP batteries with U-BMSs.

It looks that there has been an isolation measurement fault(CAN message 0C1, byte 6 is 0C). Maybe therefore I am not getting the voltage message at all (350). And one of the modules is blinking red.
I may need the diagnostic tool to reset, anyone that could share the software? Anyone had the same issue?

Thanks in advance!
 

·
Registered
Joined
·
25 Posts
One version of the software is available here: valencefiles
There is a can message document somewhere on DIY solar. Diag tool doesn't reset modules , but I have had some come back to life when charged gently but they are very low capacity due to weak cells.
 
1 - 2 of 2 Posts
Top