Wire it per the application manual, put a load on the output, and switch on the input power. Make sure the gate (if it has one) is wired correctly to enable the DC-DC.
It's started i measure dc volt on output 12 volt was on output but with in second blast in brick may be brick is faulty because is pull out friom another supply or not working without load
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
A forum community dedicated to DIY electric car owners and enthusiasts. Come join the discussion about electric vehicle conversions, builds, performance, modifications, classifieds, troubleshooting, maintenance, and more!