Cut out a template out of paper until it fits nicely around the motor. Then trace it onto a piece of galvanized sheet metal and cut out using shears. Finally daisy chain a few hose clamps (unless you find a huge one that fits all around) it to fix it to the motor. Just wear decent gloves when working with sheet metal, and ideally debur the edges after you cut it out so it's not razor sharp.
1 - 1 of 3 Posts
1 - 1 of 3 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
DIY Electric Car Forums
A forum community dedicated to DIY electric car owners and enthusiasts. Come join the discussion about electric vehicle conversions, builds, performance, modifications, classifieds, troubleshooting, maintenance, and more!
Full Forum Listing
Recommended Communities
Join now to ask and comment!
