DIY Electric Car Forums banner
1 - 6 of 6 Posts

·
Registered
Joined
·
78 Posts
Discussion Starter · #1 ·
I have the Brusa NLG513 charger, but the charging cable that came with it has the wrong connector on it. Anyone have the correct one for sale or swap?


I have this end for the J1772 connection

I need the upper mating male pin connector/cable

I have this cable which is the wrong one for sale/swap.
 

·
Registered
Joined
·
78 Posts
Discussion Starter · #3 ·
Yes, one of the cables in my hand goes to the Brusa from the J1772. it is the last picture that shows the wrong cable that I am trying to swap with someone... I have no idea what it is supposed to connect to.
 

·
Registered
Joined
·
78 Posts
Discussion Starter · #5 ·
The J1772 is the connector that is standard for the public charging stations.
SO I have charging station to charger, and am working on charger to battery. I will use the cable I have but replace the connector. I am actually working on it right now. I have narrowed it down this far so far: https://www.digikey.com/products/en...003&page=1&quantity=0&ptm=0&fid=0&pageSize=25

I am trying to figure out the difference between these, I see one is crimp, vs pin lock, and then ??? And I need to find the housing next that will go around this connector and lock in.
https://www.digikey.com/products/en...003&page=1&quantity=0&ptm=0&fid=0&pageSize=25
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top