DIY Electric Car Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
201 Posts
Discussion Starter · #1 ·
Does anyone know how to assemble one of these XINXI XXC105-EV-S2TB connectors?

I just bought a new Elcon UHF IP67 6.6kW CAN bus charger and it uses this type of connector. They supplied the connector but they don't have any instructions nor know how to assemble them.

I suppose I can muddle through if I have to but there are a couple of ferrules included that I don't exactly know where to place.

thanks,
 

·
Registered
Joined
·
201 Posts
Discussion Starter · #2 ·
Answering my own question for the benefit of at least one person I know of (Martin)...

First, I found the document on XINXI's website, here:

http://www.xinxikjcn.com/static/upload/image/2017/3/9/173516584602823.pdf

and I've attached a copy here for future reference.

The connector used by Elcon starts on page 8. You can copy and paste the Chinese into Google Translator. I'll leave that as an exercise to the reader, but have attached an example below.

For the figure captions I had to find a Chinese native to translate for me. I've attached the translated figures below.

The main thing to know is that those little rings, you don't need them. Those are for shielded cable applications (not for a DC charger).
 

Attachments

1 - 3 of 3 Posts
Top