DIY Electric Car Forums banner
1 - 1 of 2 Posts

· Registered
171 Posts
0-5 volts throttle requires NC safety switch, did you connect it? Also, are you sure you got all the wires wired correctly to the 4pin connector, in the manual pins are viewed from the controller side.

Do you have the programmer? If yes, you can debug the throttle with it, it shows the throttle level on it's display:

1 - 1 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.