DIY Electric Car Forums banner
1 - 1 of 2 Posts

· Registered
1 Posts
Discussion Starter · #1 ·
Connected to 0-5 volts throttle and will not spin the motor unless disconnect one of the variable voltage cable, move the throttle past the 1/2 point and then connect the variable voltage cable, the motor will spin and monitor will show 50 % or more throttle, if throttle is lowered below 1/2 point the motor stops spinning and set throttle error message
1 - 1 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.