DIY Electric Car Forums banner
1 - 3 of 3 Posts

· Registered
Joined
·
5 Posts
Discussion Starter · #1 ·
Hi all. I'm upgrading from a Curtis 1231C to a Zilla 1k to refresh my EV grin.



The 1231C used a common power connection for B+ and M+, however these are separated on the Zilla (and I do not measure continuity between). What topology does the Zilla use that B+ is not connected to M+?



Anyway, running a separate M+ cable to the controller will be a moderately difficult job. I assume this is really needed? Grr, thought I could knock this out today. I can't find anything in the archives or online about this..



Thanks,
Chris
http://www.evalbum.com/4743
 

· Registered
Joined
·
19 Posts
hi i just finished my project i will give you wire diagram if needed
 

Attachments

1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top